How to run a job

First steps

In order to make the worker nodes run a parallel job, you have to prepare a job script. This script tells the queue manager what you want to do, it has to be submitted with the qsub command. A typical job script looks like this:

#
#PBS -l nodes=1:ppn=1
#
sleep 120
echo "Hello world!"

This job does nothing for two minutes, after that it prints "Hello world!". The script starts with #PBS, which is a directive for Torque (the resource manager). In this example it means that you tell the queue manager to use one CPU (ppn:1) on one node (nodes=1) for this job. There can be more than one directive, they should always be at the start of the script. The remaing lines in this example are just commands that you could type on the command line.

Assuming that the name of the script is it can be submitted like this:

qsub job1

The qsub command responds with a job id, wich looks like this: 24.hpc10.hpc. The part before the first dot is system wide unique number that's increased by 1 for every new job that is submitted.

You can check if your job is running with the qstat command. This command by itself gives a list of all running jobs, the job you just submitted will probably be one of the last down the list. For a wider list with slightly more information type qstat -a:

[jsmith@hpc10:~]$ qstat -a

hpc10.hpc: 
                                                                                  Req'd    Req'd       Elap
Job ID                  Username    Queue    Jobname          SessID  NDS   TSK   Memory   Time    S   Time
----------------------- ----------- -------- ---------------- ------ ----- ------ ------ --------- - ---------
24.hpc10.hpc            jsmith      q1       job1              17395     1      1    --        --  R       -- 
[jsmith@hpc10:~]$ 

The part that tells you if your job is running is the second to last column, if this is a capital Q, then you job is waiting for a free worker node, if it is a capital R, then your job is running. If you only want to see the job you just submitted, type qstat -a followed by the job id:

qstat -a 24.hpc10.hpc

Once the commands in your job script are finished, your job will be terminated automatically. You can terminate the job yourself with the qdel command, like this:

qdel 24.hpc10.hpc

As long as your job is running, there will be two temporary files in your home directory, like 24.hpc10.hpc.OU and 24.hpc10.hpc.ER, these names correspond with the jobd id. The output and error messages that would normally be printed on the command line will be redirected to these temporary files. If your job is finished, these files will be renamed to ...